EnviRestore Glass Stain Remover is a restorative cream that removes stubborn stains from glass surfaces, and is most commonly used to remove stains that have not damaged the surface of the glass such as: waterproofing overspray, oils, soap scum, light stains, and caulking residue.
In situations where stains have damaged the surface of the glass, we recommend Glass ReSurfacer Final Polish.
Glass Defender® Series, invisible glass protection.
This product is formulated for use on plate or tempered glass surfaces, but will often work on aluminum and other exterior architectural surfaces.
This product removes stains caused by foreign materials from the glass surface, but will not repair damage caused to the glass surface as a result of corrosion. Product may cause minor scratching which can only seen when glass is viewed in direct sunlight. To avoid this, use Presto’s Glass ReSurfacer® System in order to remove all types of glass stains and repair damage. The Glass ReSurfacer system produces optical distortion-free results.
250-500 sq. ft. per qt. depending on level of staining
Clean surface prior to use. Remove dirt or sand which may scratch the glass. It is extremely important that the application pad or towel used with this product is not contaminated with abrasives. Always test in a small, inconspicuous area in direct sunlight prior to use.
Apply this product to previously cleaned surface with a sponge, white, non-abrasive pad or a soft towel. Apply a small amount of product to the applicator. Agitate the product on the surface until the stain is removed, wiping away any excess residue. Do not use excessive pressure or minor scratching can occur. To remove oily stains, apply product and allow the product residue to dry to a white powder. Remove the white material by using a dry towel or white, non-abrasive pad. Do not inhale any dry dust from this product. In some instances, a second or third application may be required. If Presto’s Glass Defender Series will be applied after the restoration process, DO NOT use or oily detergents containing surfactants to clean the surface.
Even though this product is designed to be an employee safe alternative, we recommended limiting bodily contact with any cleaning product. This product may cause minor scratching when too much pressure is applied or when used in conjunction hard pads or a motorized polisher. While these results may be acceptable, it is best to perform a test area in direct sunlight so that both contractor and client are aware of the outcome.
Following restoration, we recommend the use of Presto’s Glass Defender® MD or Glass Defender® HD to seal the glass and preserve the finish for up to 20 years.
The information provided by Presto for the safe and effective use of this product, and all of our products, is believed to be good and accurate. However, due to the many different possible applications of this product, careful considerations should be made when selecting its suitability for each surface.
The information provided should never be substituted for individual testing to ensure the product’s compatibility with each surface intended for use. The purchaser shall assume all responsibility for determining the suitability of this product. When used as intended, this product will perform as stated. No other warranty can be made for this product, verbally or written.
Presto warrants this product to be free from defects. In the event this product is found to be defective, we will provide a sufficient amount of product to replace the defective product.
When removing stains causes by mineral leaching from stone surfaces such as concreter, precast and GFRC, we recommend the use of Leach Stop Mineral Leaching Mitigation Treatment to order to help to prevent further staining on the glass after the glass restoration process.
Glass Protection Prevents Glass Stains
After removing the stains from glass surface we recommend the use of high performance glass protective treatment such as Glass Defender to create a silicone hybrid polymer coating on the newly restored surface. In the future if and when contamination comones in contact with the glass the polymer berrior will allow the stains to be removed much easir than the glass surface.
The use of high mineral content tap water and improper window cleaning detergents help to cause glass metal and stone stains. Using Deionized water and, only if necessary, a detergent such as Scumfrees Window Cleaning Detergent will help to preserve the glass restoration investment.
To learn more about how and why buildings get stained due to current outdated building maintenance procedures, download our brochure that explains how a company can save millions on their entire portfolio by using Presto products and revolutionary techniques to restore and preserve the exterior of their commercial properties.
View All Products > Architectural Window Glass Stain & Scratch Removal Products > Glass Restoration Products >